$31.00
The Keepa Vent product line is ideal for flat roof ventilation. AVP offers a 3 inch diameter roof vent with an 8 inch tall collar. This roof vent has an NFA of 7 sq. inches and a standard 8” x 8” square flange.
The 3 inch Keepa Attic Vent is ideal for ventilating low slope or flat roofs. Likewise, it's typically for ventilating attics or plenums as a roof exhaust vent or as an air intake roof vent. The vent head is removable therefore allowing easy installation on EPDM or TPO roofs. In addition, this roof vent is compatible with membrane roofs. Click here to view our installation guides.
Additionally, because of its small size, this roof vent is suitable for ventilating bathroom fans and range hoods.
To determine the number of roof vents you may need, see the Vent Calculator.
The 3 inch Keepa Attic Vent removes moisture from the attic during the winter and heat during the summer. In return, this will extend the life of the building structure. The 8 inch tall collar is suitable for locations that accumulate high levels of snowfall. In addition, the round design is aerodynamic to withstand wind speeds up to 200 mph.
As a result, this roof vent is ideal for installation in climate zones 1-6. Most importantly, the Keepa Attic Vent comes in an array of sizes with an optional curb mount flange for additional clearance or tailpipe adaptor allowing for duct ventilation.
For any questions please see the frequently asked questions page, email the sales team at [email protected], or call 845-565-7770
AVP's Keepa Vents are UL Listed and rated up to 50+ PSF or wind pressure above 200 MPH. Certified by the Texas Department of Insurance, Florida State Approved and Conforms to the Standards of CALFIRE.
   |  |   |
|---|
| Installation Instructions - pdf |
|---|
 |
The diameter size of all roof vents determines the Net Free Area, also known as the "NFA". NFA is the measured amount of opening each vent offers at each specific size. to be available for venting air through a specific vent size. The calculator below will find the overall number of vents needed to effectively ventilate the targeted attic space.
Once you have the area, the numbers shown below are the number of vents of that size which would ventilate the specified area with both 1/300 and 1/150 rule.
*Please note
The roof vent calculation values shown above are for the exhaust portion of the roof. The same amount of net free air inches is needed for air intake as well. Proper roof ventilation consists of 50% air exhaust and 50% air intake.
$31.00
