A roof curb is a box that acts as an extension from the roof deck. This extension provides a platform to mount a roof vent or exhaust fan.
AVP’s roof curbs are made from aluminum and are offered in 3 height options. For climates with minimal snow or no snow at all, a 6” height is sufficient. In moderate snow climates, AVP offers a 12” high curb. Lastly, high snow climates should use an 18” high curb. As a result, providing additional height allows for installation in all climate zones.
An important reason for the use of a roof curb is for a roofing manufacturer's warranty. Many EPDM, PVC & TPO roofing manufacturers require roofing penetrations to be secured by a curb and a boot. Check with your roofing materials supplier to purchase a boot that slides over the aluminum curb.
The boot provides a factory-approved attachment to the roof deck’s membrane. The upper end of the boot folds into the curb. Then the curb mount flange goes over both the boot and curb. This will provide a perfect seal from the top.
AVP also offers these curbs with insulation using Johns Manville’s Foil Faced Polyisocyanurate Board Insulation. This provides a smooth surface resistant to absorption. As moisture laden air moves through the roof curb to the vent or exhaust fan, there’s no loose insulation to absorb moisture. Instead, the moisture will pass through the insulated roof curb and vent directly outside.
An additional benefit to using a roof curb is it can act as a hatch or access entry port. The roof vent or exhaust fan can be easily removed. As a result, allowing for quick access to ductwork, electrical lines, or maintenance in the attic below.
Traditionally, roofers build wooden boxes on the roof at the time of the membrane installation. Using perfricated aluminum curbs eliminates the time and need to build the wooden boxes. This will also lower the risk of injury during installation by lowing the time spent on the roof. In addition, any chances to damage the roof in the building process are also lower.
Another safety feature is that aluminum curbs are not flammable. The majority of curbs vent out heat from range hoods or HVAC units. This heat can cause wooden curbs to burn. However, aluminum will not burn, rust, or corrode. Aluminum curbs are safer and easy to clean.
Insulation is also available for an extra layer of protection. AVP uses 1” thick board with an R-6 value for the RC-12 to RC-48 models. Fiberglass insulation for 1” is around R-3 value. The ridged board provides double the amount of insulation value available per inch of thickness. The models RC-3 to RC-10 use a ½” Johns Manville’s Foil Faced Polyiso Board Insulation. This ½” board provides an R-2.7 value.