The Pop Vent “Roof Louver” is used for ventilating steep slope roofs. PV-12-C02 is a 12 inch in diameter roof vent that has a 2 inch tall collar. This means that the vent has a 2 inch clearance between the base and the inner louvers. The PV-12-C02 has 113 inches of net free area (NFA) and comes with an 18 X 18 square base or flange. When used for roof exhaust the PV-12-C02 can be used in climate zones 1 through 8 if the roof pitch is 4/12 or greater and the vent is no more than 18 inches down from the peak of the roof.
Model PV-12-C02 will alleviate moisture in the winter and heat in the summer and extend the life of the roof. The Pop Vent’s top (lid) is manufactured and spun out of one solid piece of aluminum making it corrosion resistant.
The Pop Vents louvers allow hot air to escape freely and efficiently while keeping out birds, insects and animals out of the attic. The round aerodynamic design can with stand harsh weather and wind pressure exceeding 200 mph.
The 12 inch Pop Vent is great for residential roof applications because it is low profile and that it can be painted to match the color of the asphalt shingles.
Pop Vents are UL Listed and rated up to 50+ PSF or wind pressure above 200 MPH. Certified by Texas Department of Insurance, Florida State Approved & Conforms to the Standards of CALFIRE.
|Product Link||Installation Instructions - Shingled Roof - pdf||Installation Instructions- Flat Roof - pdf|