The 42 inch Aura Gravity Ventilator with Curb Mount Flange is 42 inches in diameter and has a 6 inch tall collar. The model number is AV-42-C6-CMF and has 1,384 inches of Net Free Area (NFA). All 42 inch gravity ventilators come with a standard 46″ x 46″ square curb mount flange.
This roof vent has a curb mount flange which allows for easy access to the attic or duct below. In other words, the flange is designed to fit over roof curbs or an existing base of the same diameter. As a result, this gives the vent head extra clearance allowing for installation in all climate zones.
The Aura Gravity Ventilator works like a roof turbine but with no moving parts.
Aura Gravity Ventilators rely on the Venturi Effect when the wind blows against the outer louvers. As a result, this creates an upward draft allowing air to freely flow in and out of the vent. The Aura Gravity Ventilator removes heat in the summer and moisture from the attic in the winter. This allows for year-round ventilation on low slope or flat roofs.
Even the smallest breeze can create exhaust ventilation to draw air out of the gravity vent. Therefore, wind speeds of 11 mph for a 42 inch Gravity Ventilator produces 3,807 CFM of air exhaust.
In addition, Aura Gravity Vents are UL Listed and rated up to 50+ PSF or wind pressure above 200 MPH. Certified by Texas Department of Insurance, Florida State Approved & Conforms to the Standards of CALFIRE.
The diameter size of all roof vents determines the Net Free Area, also known as the "NFA". NFA is the measured amount of opening each vent offers at each specific size. to be available for venting air through a specific vent size. The calculator below will find the overall number of vents needed to effectively ventilate the targeted attic space.
Once you have the area, the numbers shown below are the number of vents of that size which would ventilate the specified area with both 1/300 and 1/150 rule.
The roof vent calculation values shown above are for the exhaust portion of the roof. The same amount of net free air inches is needed for air intake as well. Proper roof ventilation consists of 50% air exhaust and 50% air intake.
Showing the single result