Keepa Commercial Roof Jack Vent Cap

Keepa Roof Jack With Tailpipe From Bottom
Keepa Roof Jack With Tailpipe Looking down at an angle

Our Keepa Roof Jack is to be used in conjunction with a ducted system.

The Miami-Dade County Approved Keepa Roof Jack is used for ventilating bathroom fans or other duct applications. In addition, the round design is aerodynamic to withstand wind speeds up to 200 mph. It allows for maximum air to flow while alleviating back pressure. As a result, this attic vent is suitable for installation in all climate zones. Most importantly, the Keepa Attic Vent comes in an array of sizes with optional curb mount flange for additional clearance.

The Keepa Roof Jack is engineered to stop insects and wildlife from entering the duct. It is also designed to prevent rain or snow from entering in all US climate zones. The Keepa’s standard 11 inch collar height is great for low slope or flat roofs. These vents have an all-aluminum construction. To clarify, this means they are durable, lightweight, and will not rust.

The Roof Jack’s tail pipe is approximately 2 inches long and is corrugated at the bottom to fit existing duct work. This allows for a quick and easy installation. In addition, the head of the Keepa Vent is removable, therefore allowing easy access for maintenance to the duct below.

Keepa roof vents are UL Listed and rated up to 50+ PSF or wind pressure above 200 MPH.  Certified by Texas Department of InsuranceFlorida State Approved & Conforms to the Standards of CALFIRE.

For any questions please see the frequently asked questions page. If you still have questions, email the sales team [email protected] or call 845-565-7770


Collar Height

Overall Height

linkedin facebook pinterest youtube rss twitter instagram facebook-blank rss-blank linkedin-blank pinterest youtube twitter instagram